SURROUND

Auro-3D setup on Windows 10

Using Windows 11? See this guide →
  1. 01

    Connect a PC to an HDMI supported AV receiver. On the AV receiver, select the Auro-3D mode.

    • ※How to operate the receiver differs by model. Please refer to its owner’s manual.
  2. 02

    From the [Start] button, go to [Windows System] – [Control Panel]. Open [Sound] settings. Right-click on your device from (1) and select [Set as Default Device].

  3. 03

    Click on [Configure] at the bottom left and select “5.1 Surround” for Auro 9.1ch content, or “7.1 Surround” for Auro 11.1ch or 13.1ch content. Click [Next] and complete the speaker configuration setting.

    • ※If two “5.1 Surround” configurations are shown, select the one shown in the image below.
  4. 04

    Go back to the [Sound Settings] window from (2) and click [Properties] at the bottom right. Under [Default Format] in the [Advanced] tab, select the sample rate that matches the content (and select the largest bit depth). For example, for 48kHz streams, select [24bit, 48000Hz] and click [OK]. If the [Advanced] tab shows “Enable audio enhancements”, turn it off.

  5. 05

    Set the level to 100 in the [Levels] tab.

  6. 06

    Set the player volume to the maximum level and enjoy the content.

    • ※Adjust the volume on the AV receiver.
  7. 07

    Check the input signal with the INFO button on the remote or on the AV receiver, and make sure that Auro-3D is recognized correctly.

    • ※The images below are examples from DENON and Marantz products. “ACTIVE SPEAKERS” differs depending on your speaker configuration.
    • ※How to operate the receiver differs by model. Please refer to its owner’s manual.
    Auro 9.1ch
    Auro 9.1ch
    Auro 11.1ch
    Auro 11.1ch
    Auro 13.1ch
    Auro 13.1ch

Surround / Auro-3D

← All playback guides